How to Fit a Grove Cabinet Latch
By Timeless Furniture, Lighting & Homeware | Rowen & Wren | Published: 2026-10-30
Category: How-to Guides
Learn how to install a Grove Cabinet Latch in aged bronze with simple tools. Step-by-step guide for a secure, easy-fitting cabinet latch.
Quick answer
Gather a drill, screwdriver, and pencil. Mark the latch position on the cabinet frame, drill pilot holes, then screw the latch in place. Check alignment before tightening fully.
What you need before you start
The Grove Cabinet Latch comes as a single solid bronze piece with screws included. You will need a drill with a 2mm bit for pilot holes, a Phillips screwdriver, a pencil, and a tape measure. A level is optional but helpful for visual alignment.
Choosing the right cabinet type
This latch works on framed and frameless cabinets with a standard overlay door. It is not suitable for sliding doors or cabinets with inset doors where the latch would interfere with the door edge. Measure your door overlap to confirm clearance.
Step-by-step installation guide
- Mark the latch position: Hold the latch against the inside of the cabinet frame at the desired height. Use a pencil to mark the two screw holes through the latch. Common mistake: marking too close to the door edge can cause the latch to bind when the door closes. Check that the latch sits at least 10mm from the door edge to avoid interference.
- Drill pilot holes: Using a 2mm drill bit, drill pilot holes at the marked points. Drill straight and only to the depth of the screw length (about 15mm). Common mistake: drilling too deep or at an angle can split the cabinet frame or misalign the latch. Drill slowly and stop when the bit reaches the screw depth.
- Attach the latch: Align the latch over the pilot holes and insert the screws. Tighten them with a screwdriver until the latch is snug but not over-tightened. Common mistake: over-tightening can strip the screw heads or crack the frame. Stop turning as soon as the latch feels firm against the frame.
- Test the latch operation: Close the cabinet door gently and check that the latch clicks into the strike plate (if present) or catches the door edge. Open and close a few times to ensure smooth action. Common mistake: if the latch does not engage, the position may be too high or low. Adjust the latch slightly by loosening the screws and shifting it up or down by 1-2mm.
About the product
- Grove Cabinet Latch, Aged Bronze: Crafted from solid bronze, so it has a pleasingly weighty feel. The weight and durability mean the latch will stay securely closed over years of use without loosening.
Grove Cabinet Latch, Aged Bronze - Grove Cabinet Latch, Aged Bronze: A natural finish designed to change with use, lightening in areas to reveal the solid bronze beneath. The aged bronze patina will develop character over time, so avoid over-polishing or using abrasive cleaners.
