Quick answer
Choose one finish as the dominant tone and use the second sparingly on a different hardware type—for example, matt brass cup handles on drawers and aged bronze knobs on doors—so the mix reads as intentional rather than accidental.
Why a dominant finish keeps the mix calm
Two metallic finishes on one cabinet can look collected or chaotic depending on proportion. A practical rule is to let about two-thirds of the visible hardware share one finish, then introduce the second finish on a distinct hardware shape or zone. That gives the eye a resting place and stops the cabinet from looking like a sample board.
This matters most on kitchen cabinetry, where hardware repeats many times. A single drawer with a different finish can read as a deliberate accent; alternating finishes drawer by drawer usually reads as indecision.
Where the two finishes naturally diverge
Matt brass and aged bronze sit close enough in warmth to pair without clashing, but they age differently. Matt brass develops a patina over time, while aged bronze is designed to lighten with use and reveal the metal beneath. On a well-used kitchen, that means the two finishes will drift further apart—not closer together—so check them in your actual light before committing.
If the cabinet is in a low-light hallway or a north-facing kitchen, the difference between the two finishes will be subtler; in bright daylight, the contrast is more obvious. Neither is wrong, but the room should guide how boldly you mix.
Steps to mix finishes on one cabinet
- Audit the cabinet's hardware zones: List every door and drawer and note which type of hardware each currently uses. Decide which zone will carry the dominant finish—usually the largest run of drawers or the most-used doors. If a zone has only one piece of hardware, it is too small to anchor a finish; group it with a larger run instead.
- Assign one finish per hardware type: Keep knobs in one finish and handles or cup pulls in the other. For example, use the Grove Flattened Knob in aged bronze on doors and the Grove Drawer Handle in matt brass on drawers. Avoid mixing finishes within the same hardware type on adjacent pieces; that is the most common cause of a patchwork look.
- Set the ratio before drilling: Aim for roughly two-thirds dominant finish to one-third accent. Count the pieces and adjust the plan before making new holes, especially if you are updating furniture with knobs. If the accent finish exceeds about a third of the visible hardware, it stops reading as an accent.
- Check placement height and spacing: For kitchen cabinet knob placement, fit knobs centred on door stiles and handles centred on drawer fronts. Keep the centre lines consistent across the run so the two finishes do not exaggerate small misalignments. Measure from the cabinet edge, not the existing holes, if you are replacing hardware with a different profile.
- Live with the layout before final fixing: Tape or temporarily fit the pieces and view them at different times of day. Both finishes change with light and use, so confirm the contrast works in the room's actual conditions. If the mix feels busy, revert to a single finish rather than adding a third tone.
Two pieces that pair well
- Grove Drawer Handle, Matt Brass: A slender cupped drawer handle in solid brass with a natural finish designed to patina over time. Its slim profile suits drawer fronts where a knob would feel bulky, and the patina means the brass will soften rather than stay bright.

Grove Drawer Handle, Matt Brass - Grove Flattened Knob, Aged Bronze: A circular cabinet knob in solid bronze with a flattened face and fluted stem, finished to lighten with use. The flattened face gives a subtle contemporary look on doors, and the changing finish means it will gradually contrast more with any brass nearby.

Grove Flattened Knob, Aged Bronze


